Rail transport or train transport is one of the main transportation modes these days, both for transferring passengers and goods. Every day people commute to work and back home using trains in a form of subway systems, light rail transits and other types of rail transport. These types of system can create noise both to the passengers inside of the train as well as to the environment. In this article, we will discuss about noise source components that we hear daily both inside and outside of the train.
If we pay attention to the noise when we are on board of a train, there are more than one noise source that we can hear. The main sources for interior noise in a train are turbulent boundary layer, air conditioning noise, engine/auxiliary equipment, rolling noise and aerodynamic noise from bogie, as illustrated in the following figure.
By the way, we wrote and recorded the sound of Jakarta MRT. You can see the link below to help you imagine the train situation better.
Exploring Jakartan Public Transportation Through The Sound
Rolling noise is caused by wheel and rail vibrations induced at the wheel/rain contact and is one of the most important components in railway noise. This type of noise depends on both wheel and rail’s roughness. The rougher the surface of both components will create higher noise level both inside and outside of the train. To be able to estimate the airborne component from the rolling noise, we must consider wheel and track characteristics and roughness.
Another noise component that contributes a lot to railway noise is aerodynamic noise which can be caused by more than one sources. These types of sources may contribute differently to internal noise and external noise. For example, aerodynamic noise contributes quite significantly at lower speeds to internal noise while for external noise, it doesn’t contribute as much if the train speed is relatively low. For example, on the report written by Federal Railroad Administration (US Department of Transportation), it is stated that aerodynamic sources start to generate significant noise at speeds of approximately 180 mph (around 290 km/h). Below that speed, only rolling noise and propulsion/machinery noise is taken into consideration for external noise calculation. In addition to external noise, machinery noise also contributes to the interior noise levels. This category includes engines, electric motors, air-conditioning equipment, and so on.
To perform the measurements of railway noise, there are several procedures that are commonly followed. For measurement of train pass-by noise, ISO 3095 Acoustics – Railway applications – measurement of noise emitted by rail bound vehicles,is commonly used. This standard has 3 editions with the first published in 1975, and then modified and approved in 2005 and again in 2013. The commonly used measures for train pass-by are Maximum Level (LAmax), Sound Exposure Level (SEL) and Transit Exposure Level (TEL).
For interior noise, the commonly used test procedure is specified in ISO 3381 Railway applications – Acoustics – Measurement of noise inside rail bound vehicles. This procedure specifies measurements in few different conditions such as measurement on trains with constant speed, accelerating trains from standstill, decelerating vehicles, and stationary vehicles.
Acoustical Design Engineer
D. J. Thompson. Railway noise and vibration: mechanisms, modelling and means of control. Elsevier, Amsterdam, 2008
Federal Railroad Administration – U.S. Department of Transportation, High-Speed Ground Transportation Noise and Vibration Impact Assessment. DOT/FRA/ORD-12/15. 2012